Utility
12
d-Color MF25 12-61
7 Check the distance from the refer-
ence black lines to the cyan lines in
the test pattern along the X and Y di-
rections.
– If the lines are shifted in the X di-
rection as shown below, touch [–
] under “X” to reduce the adjust-
ment (between –1 dot and –6
dots).
– If the lines are shifted in the X di-
rection as shown below, touch [+]
under “X” to increase the adjust-
ment (between 1 dot and 6 dots).
– If the lines are shifted in the Y di-
rection as shown below, touch [–
] under “Y” to reduce the adjust-
ment (between –1 dot and –6
dots).
– If the lines are shifted in the Y di-
rection as shown below, touch [+]
under “Y” to increase the adjust-
ment (between 1 dot and 6 dots).
– Each time [+] or [–] is touched, the
value is increased or decreased
by one increment.
– If the lines are not shifted from
the reference lines, skip to step
10.
8 Press the [Start] key.
The adjusted test pattern is printed.
?
When is the adjustment applied?
% The adjustment is applied when the [Start] key is pressed. To can-
cel the adjustment, touch [Cancel] instead of pressing the [Start]
key.
To Next Page
Loading...
Need help?
General