EasyManuals Logo

Omron CQM1 User Manual

Omron CQM1
312 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #285 background imageLoading...
Page #285 background image
266
IOTC(––) Section 2-7
SET
01600
CMP (20)
#FFFF
001
@ASL (25)
016
IOTC (––)
DM 0000
DM 0100
DM 0200
@ASL (25)
016
01700
25315
01600
25506 (=)
01601
25506 (=)
25503 (ER)
SET
01701
00115 00114 00113
00112
01601
IOTC (––)
DM 0007
#CCD2
DM 0202
@ASL (25)
016
01702
01602
25506 (=)
25503 (ER)
01701
IOTC (––)
DM 0007
#CFC2
DM 0203
@ASL (25)
016
01603
25506 (=)
IOTC (––)
DM 0007
#CCDA
DM 0204
@ASL (25)
016
01604
25506 (=)
IOTC (––)
DM 0011
DM 0102
DM 0205
DIFU (13)
01800
01605
25506 (=)
01800
01704
END (01)
Power ON and Unit initialization completed.
Unit reset after initialization. FFFF indicated
for binary indications.
I/O allocation commands sent.
(Writing set point and control cycle)
Normal end to I/O allocation commands.
Macro instruction error occurred. (Com-
mands must be repeated after debugging.)
Checking write parameters
RUN start for loop 2.
RUN acknowledged.
Macro instruction error.
Loop 2 autotuning started.
AT command acknowledged. (AT command
must be change after it is acknowledged. It
will be repeated if not changed.)
RUN start for all loops (wildcard command)
RUN acknowledged.
Process value monitor for all loops.
Turns OFF input condition for IOTC(––) for
one scan to ensure continuous execution)
Error check
01605 00115 00114
00112
00113
01600: Work bit
(1) Changing the Set Point and Control Period
(2) Operation Control Commands
(Leftmost 4 bits in IR001 will be "1110" (E) if an
error has occurred and IR 01701 will be turned ON.
(3) Monitoring Process Values

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron CQM1 and is the answer not in the manual?

Omron CQM1 Specifications

General IconGeneral
ModelCQM1
I/O CapacityUp to 256 I/O points
Programming LanguageLadder Logic
Timer/Counter128 timers/counters
Operating Temperature0 to 55°C
Humidity10 to 90% RH (non-condensing)
Power Supply24 VDC or 100-240 VAC
Communication PortsRS-232C
Memory Capacity3.2K words
Instruction SetBasic and advanced instructions
MemoryRAM (battery-backed)
Program Memory3.2K words
Storage Temperature-20 to 75°C

Related product manuals