OpAL Oxford Instruments Plasma Technology System Manual
System Identification
This system, Works Order No. for Customer: , is identified
by a label attached to the rear of the power box. An image of this label is shown below:
94-417919 Università di Pisa
NOTE: Refer to the label attached to the system power box for the measured maximum
rated input current value.
Quality Control forms
The following Quality Control Forms (QCF) are attached:
Goods Return Form QCF 60 – To be completed and attached to the outside of the
package of any returned parts.
Certificate of Pre-Acceptance and Certificate of Acceptance QCF 61 – To be completed
and returned if the customer is absent from acceptance.
System Readiness Form QCF 89 – To be completed and returned prior to the
commissioning visit.
Declaration of Conformity QCF 185d - CE Certificate.
Preface
Printed: 14 July 2010 08:52 Page (v) Issue 1: July 2010
To Next Page
Loading...
