Internal Assemblies — Front Case 4: Repair
95
LCD Display
NOTES: There are two versions of the LCD Display available for DFM100. To find P/Ns of LCD Display
Assembly, refer to Tabl e 3 7 on page 179.
453564489521 DFM100 CBL LCD Display to Processor can be only used for 453564488961DFM100
Display ASSY.
No signal LCD Display cable is available for 453564587191 DFM100 Display ASSY 1.1.
You need the following tools for this repair:
1 75% Isopropanol Alcohol
2 Hot Melt Glue (3M)
3 Hot Melt Glue Gun (3M Scotch-weld hot melt applicator 0.15KW/240V)
Preparation
1 Open the Case. See “Opening the Case” on page 90.
2 Position the Efficia DFM100 display side down.
Removal LCD Display R1.0
1 Press middle area and lift right side of the two plastic cable fasteners to loose the fasteners, see
Figure 61.
Figure 61 LCD Display Assembly-1
2 Remove the five M 3x10 screws with washers ( to ), see Figure 62 A. Screw and are
underneath the cover.
NOTE: Screw is under white circle and screw is under yellow circle.
3 Remove the LCD Display R1.0 Assembly, see Figure 62 B.
To Next Page
Loading...