4: Repair Internal Assemblies — Main Chassis
120
To Complete the Replacement
Run Performance Verification and Safety testing as described in the “Performance Verification”
chapter.
NOTE: You can also remove the SpO2 PCA after you opening the Main Case. See “Opening the Case” on
page 90.
SpO
2
PCA Standoffs
There are two plastic SpO
2
PCA Standoffs installed on the Processor PCA. They are used for supporting
the SpO
2
PCA installation. The standoffs are screwed on the processor PCA directly.
Preparation
1 Open the Case. See “Opening the Case” on page 90.
2 Remove the Measurement Module. See “Measurement Module” on page 107.
3 Remove the SpO
2
PCA. See “SpO2 PCA” on page 119.
Removal
1 Use your hand to remove the two SpO
2
PCA standoffs on the Processor PCA, see Figure 95.
Figure 95 SpO2 PCA Support Pillar
Replacement
1 Use your fingers to install new nylon standoffs. Do not overtighten the standoffs. See Figure 95.
2 Install the SpO
2
PCA. See “SpO2 PCA” on page 119.
3 Install the Measurement Module. See “Measurement Module” on page 107.
4 Close the Case. See “Closing the Case” on page 149.
To Complete the Replacement
Run Performance Verification and Safety testing as described in the “Performance Verification”
chapter.
To Next Page
Loading...