Philips Efficia DFM100 - External Assemblies; Battery Compartment Cover and Latch

External Assemblies 4: Repair
79
External Assemblies
This section describes how to remove and replace assemblies that are external to the case. You do not need
to open the case for any of these procedures.
NOTE: See the Efficia DFM100 Instructions for Use for information on attaching the carrying case and accessory
pouches.
This section is organized into the following topics:
 Battery Compartment Cover and Latch . . . . . . . . . . . . p. 79
 Bedrail Mount . . . . . . . . . . . . . . . . . . p. 81
 Labels . . . . . . . . . . . . . . . . . . . . p. 82
 Handle Assembly . . . . . . . . . . . . . . . . . p. 84
 Paddle Tray and Plates . . . . . . . . . . . . . . . . p. 85
 Printer . . . . . . . . . . . . . . . . . . . . p. 87
 Therapy Knob / Smart Select Knob . . . . . . . . . . . . . p. 89
Battery Compartment Cover and Latch
 Preparation
1 Turn the device off and remove the battery and the AC.
2 Position the device.
Lay the device on a work surface with the display facing down and the bottom facing you.
 Removal
1 Loosen and remove the four 3.3 x 8 self-tapping screws.
2 Insert a flat-head screwdriver to loosen the compartment cover. See Figure 44.
Figure 44 Battery Compartment Cover-1