Philips Efficia DFM100 - Internal Assemblies - Rear Case Assembly; Rear Case Assembly Overview; Measurement Module

Internal Assemblies — Rear Case Assembly 4: Repair
107
Internal Assemblies — Rear Case Assembly
This section is organized into the following topics:
 Rear Case Assembly Overview . . . . . . . . . . . . . . p. 107
 Measurement Module . . . . . . . . . . . . . . . . p. 107
 Therapy Port . . . . . . . . . . . . . . . . . . p. 109
 Printer Assembly . . . . . . . . . . . . . . . . . p. 111
Rear Case Assembly Overview
The Rear Case Assembly of the Efficia DFM100 includes:
• Main Chassis (See “Internal Assemblies — Main Chassis” on page 112)
• Main PCA Module
•Back Part Assemblies
• Rear Case Assembly
•Measurement Module
•Therapy Port
•Printer Assembly
Measurement Module
 Preparation
 Open the Case. See “Opening the Case” on page 90.
 Removal:
1 Remove the Measurement Module Locking Bracket, see Figure 73.
Figure 73 Measurement Module-1
Measurement
Module
Locking
Bracket