Setting Inputs and Outputs 143
500ML Lighting Control Console
Operation Guide
Master Speed
TapSync
Measures the time between Note On commands and sets the Speed Master
to that amount.
Increase Time Time of the Speed Master will be increased by given amount.
Decrease Time Time of the Speed Master will be decreased by given amount.
Multiply Time Time of the Speed Master will be multiplied by given amount.
Divide Time Time of the Speed Master will be divided by given amount.
Manual Go
Will issue a "Go" Command to all cuelists listening to this Speedmaster. It
only applies to cuelists that are already running.
Toggle Enabled Will pause / unpause the Speed Master
Enable Will unpause the Speed Master.
Disable Pauses the Speed Master.
Flash On / Off
Works like a Flash - Speedmaster will be unpaused when the On portion of
the trigger is received and paused when the Off portion is received.
Master Fade
TapSync
Measures the time between received Note On commands and sets the
Fademaster to that amount.
Increase Time Time of the Fademaster will be increased by given amount.
Decrease Time Time of the Fademaster will be decreased by given amount.
Multiply Time Time of the Fademaster will be multiplied by given amount.
Divide Time Time of the Fademaster will be divided by given amount.
MIDI Out
Note On Defined Note On command will be output from the console’s MIDI Out.
Note Off Defined Note Off command will be output from the console’s MIDI Out.
Note On / Off
Defined Note On command will be output from the console’s MIDI Out when
a Note On is received, a Note Off will be output when a Note Off is received.
Program Change
Defined Program Change command will be output from the console’s MIDI
Out.
Timecode
Toggle Enabled The Timecode Enable / Disable setting will be toggled.
Enable The Timecode will be enabled.
Disable The Timecode will be disabled.
Reset Generator The internal Timecode Generator will be reset to the Start Value.
To Next Page
Loading...
