LIFEPAK 15 Monitor/Defibrillator
Service Manual
Replacement Procedures
Main Keypad (A10) Replacement
Section Menu Section Contents Procedures Back Index
201
8
Removing the Main Keypad (A10)
Refer to Figure 8.16 on p. 200.
To remove the main keypad from outside the front case:
1. Using a very thin, wide, flat-edged tool (example, 1.5” putty knife), gently pry one edge of the main keypad until it is released
from its adhesive mount. Take care not to damage the case.
2. Pull the main keypad away from the case, extending part of the W13 cable through the keypad opening.
3. Spread the locking tabs and disconnect the W13 cable (3207388-001) (see Figure 9.53 on p. 475) from main keypad at J39.
Make sure the W13 cable does not fall back into the front case.
Installing the Main Keypad (A10)
Refer to Figure 8.16 on p. 200.
NOTE: Before installing the new main keypad, verify that the shelf-life date printed on the main keypad package has not expired.
To install the new main keypad (see Table 9.12 on page 420 for keypad part numbers):
1. Using a soft, lint-free cloth and isopropyl alcohol, gently remove old adhesive from the main keypad cavity on the front case.
2. Connect the W13 cable (3207388-001) to the main keypad at J39.
3. Check that connector locking tab is securely latched.
4. Remove the protective covering from the keypad adhesive surface, and press the keypad firmly and evenly into the keypad cavity
on the front case.
To Next Page
Loading...
