LIFEPAK 15 Monitor/Defibrillator
Service Manual
Replacement Procedures
Display Lens Replacement
Section Menu Section Contents Procedures Back Index
207
8
Installing the Display Lens
Refer to Figure 8.19 on p. 206.
To install the display lens onto the front case:
1. Using a soft, lint-free cloth and isopropyl alcohol, gently remove old adhesive from lens frame on the front case.
2. Remove adhesive liner from display lens and install on front case. Press down firmly all around edge of display lens.
3. Make sure the display lens surface is completely clean and dust free before installing LCD assembly.
4. Install the LCD assembly as described in Installing the LCD Display Assembly (A11) (p. 205).
5. Install the interface PCB as described in Installing the Interface PCB (A05) (p. 194).
6. Reassemble the case as described in Reassembling the Case (p. 184)).
To Next Page
Loading...
