LIFEPAK 15 Monitor/Defibrillator
Service Manual
Replacement Procedures
LCD Display Assembly (A11) Replacement
Section Menu Section Contents Procedures Back Index
205
8
Removing the LCD Display Assembly (A11)
To remove the LCD display assembly from the front case (Inside Front Case Diagram (p. 189):
1. Disassemble the case as described in Disassembling the Case (p. 181).
2. Remove the interface PCB as described in Removing the Interface PCB (A05) (p. 193).
3. Remove the backlight inverter as described in Removing the Backlight PCB (A08) (p. 196).
4. Remove the display/interface cable as described in Removing the LCD Display Assembly/Interface PCB Cable (W18) (p. 226)
5. Remove the four LCD bracket mounting screws (202253-764). Discard the screws.
6. Remove the LCD mounting bracket from front case and place on workspace with LCD display assembly facing up.
7. Remove four screws (202253-761) from the LCD display assembly. Discard the screws.
8. Remove the LCD display from the LCD bracket.
Installing the LCD Display Assembly (A11)
To install the LCD display assembly into the front case:
NOTE: If a new LCD display assembly is required, use Display Repair Kit (MIN 3305431-013) (p. 505).
1. Make sure both the LCD display assembly screen and the front case lens are completely clean and dust free before reinstalling.
2. Place the LCD mounting bracket on workspace with display side facing up. Route LCD wires through Bracket openings.
3. Install the LCD display assembly onto the display mounting bracket with four new screws (202253-761); torque to 6.8 in-lbs.
4. (If installing a new LCD display) Remove protective layer from LCD screen.
5. Place the LCD mounting bracket in the front case and secure with four new screws (202253-764); torque to 6.8 in-lb.
6. Install the display/interface cable as described in Installing the LCD Display Assembly/Interface PCB Cable (W18) (p. 226)
7. Install the backlight inverter as described in Installing the Backlight PCB (A08) (p. 197).
8. Install the interface PCB as described in Installing the Interface PCB (A05) (p. 194).
9. Reassemble the case as described in Reassembling the Case (p. 184).
To Next Page
Loading...
