PREVOST X3-45 Multiplex User Manual

Section 13: WHEELS, HUBS & TIRES
PA1562
11
consist of checking pressure while the tires have
not fully cooled down which leads into under-
inflated tires. Relying on the TPMS eliminate this
mistake.
Running tires at optimal pressure reduce tire
wear, improve safety and fuel economy.
NOTE
It is more accurate to use the TPMS display to
set the tire pressures than a pressure gauge.
The TPMS target pressures are factory set to
equal the prevailing tire pressure at delivery
time.
When tire pressures are increased to account
for higher vehicle weight, the TPMS set point
need to be increased accordingly.
• Vehicles not equipped with BERU TPMS
The condition and pressure of the tires can
greatly affect both useful tire life and road safety.
At regular intervals, verify the tire pressures.
Use an accurate tire pressure gauge when
checking inflation pressures. Never exceed the
maximum inflation pressure specified on each
tire.
NOTE
Inflation pressure should be checked when
tires are cold. Cold tire inflation pressure can
be measured when a vehicle has not been
driven for at least 3 hours or less than 1 mile
(1.6 km). Driving, even for a short distance,
causes tires to heat up and air pressure to
increase. Check inflation pressure on all tires
(including the spare tire) using an accurate tire
gauge.
NOTE
The recommended tire inflation pressures are
given in the applicable documents supplied
with the vehicle. In addition, cold tire inflation
pressures are listed on the Department of
Transport's certification plate, affixed on the
panel behind the driver’s seat. For special tire
selection, a “PRÉVOST COACH SPECIAL
SPECIFICATION” chart is supplied with the
vehicle and is affixed on the left wall near the
driver’s seat. Remember, tire inflation
pressure must be adjusted according to
vehicle loading - see table in "Coach Final
Record"
FIGURE 10: TIRE INFLATION 13009
CAUTION
Never bleed air from hot tires as tires will then
be under inflated. Use an accurate tire gauge
to check pressures (Do not kick tires as an
inflation check. This is an unreliable method).
CAUTION
These tire pressures are established in
accordance with the maximum allowable load
on each axle. A lower pressure is recom-
mended if the axle load is less than the above
specifications. Weigh vehicle fully loaded and
pressurize according to tire manufacturer's
recommendations. For other tire and wheel
specifications, see Prévost tire pressure
tabulation in "Coach Final Record".

PREVOST X3-45 Multiplex Specifications

General

Length	45 ft
Width	102 in
Engine	Volvo D13
Horsepower	500 hp
GVWR	54, 000 lbs
Height	146 in
Sleeping Capacity	Varies based on floor plan
Water Capacity	Varies based on floor plan