Section 01: ENGINE
PA1562
16
1.6 ENGINE MOUNTS
The power plant assembly is mounted to the
cradle by means of rubber mounts and supports.
Two engine support brackets are used at the
front of the engine while two rubber mounts are
mounted underneath the engine & radiator fan
drive mechanism support and the engine &
alternator support (Fig. 13).
It is recommended that new rubber mounts be
installed at each major overhaul.
NOTE
Refer to the table on the following page for
engine cradle tightening torques.
FIGURE 13: VOLVO ENGINE POWER PLANT CRADLE INSTALLATION
To Next Page
Loading...