EasyManua.ls Logo

PREVOST X3-45 Multiplex - Fuel Filters; Racor Fuel;Water Separator Servicing

PREVOST X3-45 Multiplex
1422 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section 03: FUEL SYSTEM
PA1562
4
FIGURE 3: MANUAL SHUT-OFF VALVE WITH DAVCO
FUEL PRO 382 (DDC S60 ENGINE)
03073
1.3 FUEL FILTERS
The fuel system is equipped with primary
(strainer or optional fuel/water separator) and
secondary fuel filters for additional protection of
the injectors. A Racor fuel/water separator may
be installed in primary filter location (Fig. 4).
FIGURE 4: ENGINE R.H. SIDE 03069
NOTE
The operating conditions and cleanliness of
type of fuel used determine the service
intervals of the filter/water separator element
and the secondary fuel filter cartridge.
NOTE
For information on the Davco Fuel Pro 382
fuel filter, refer to paragraph 3.
1.4 RACOR FUEL/WATER SEPARATOR
SERVICING
MAINTENANCE
The Racor fuel/water separator should be
drained periodically, or when the water
separator telltale light on the dashboard
illuminates.
FIGURE 5: RACOR FUEL /WATER SEPARATOR
03025
Replace the fuel/water separator element as
follows:
1. Drain the fuel /water separator by opening
the drain valve.
2. With engine "OFF" and engine fuel supply
line shut-off valves closed; remove the filter
cartridge and bowl assembly from cover (for
valve location, see "1.2. FUEL VALVES" in
this section).
3. Separate bowl from filter cartridge. Clean
bowl and O-ring groove.
NOTE
Bowl is reusable, do not discard.
4. Lubricate O-ring with clean diesel fuel or
motor oil and place it in bowl groove.

Table of Contents

Related product manuals