EasyManuals Logo

PREVOST X3-45 Multiplex User Manual

PREVOST X3-45 Multiplex
1422 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #291 background imageLoading...
Page #291 background image
Section 07: TRANSMISSION
PA1562
11
TABLE 2
Recommended Fluid and Filter Change Intervals
1
Using 100% TranSynd
TM
/TES 295 Approved Fluid
2
Severe
3
Coaches equipped with retarder
General
4
Coaches without retarder
Filters Filters
Fluid
Main Internal Lube/
Auxiliary
Fluid
Main Internal Lube/
Auxiliary
150,000 Miles
(240 000 km)
48 Months/
6000 Hrs
75,000 Miles
(120 000 km)
36 Months/
3000 Hrs
Overhaul 75,000 Miles
(120 000 km)
36 Months/
3000 Hrs
300,000 Miles
480 000 km
48 Months/
6000 Hrs
75,000 Miles
(120 000 km)
36 Months/
3000 Hrs
Overhaul 75,000 Miles
(120 000 km)
36 Months/
3000 Hrs
1
Extended TrandSynd™/TES 295 fluid and filter change intervals are only allowed with Allison High-Capacity filters.
2
Less than 100% concentration of TranSynd™/TES 295 approved fluid is considered a mixture and should utilize non-TES 295
change intervals. If the customer replaces non-TranSynd™/non-TES 295 fluid with TranSynd™/TES 295 equivalent, the change
interval recommendations of non-TranSynd™/non-TES 295/mixture must be followed. Upon the next oil change, if the customer
reinstall TranSynd™/TES 295 equivalent, the fluid & filter change recommendation outlined in 100% TES 295 approved fluids must
be followed.
3
Severe vocation= All retarder, On/Off highway, transit and intercity coach with duty cycle greater than one (1) stop per mile.
4
General vocation= intercity coach with duty cycle less than or equal to one (1) stop per mile and all other vocations not listed in
severe vocation.
TABLE 3
Recommended Fluid and Filter Change Intervals Using 100% TranSynd
TM
/TES 295 Approved Fluid And Gold
Series Filters
Coaches equipped with retarder Coaches without retarder
Filters Filters
Main Main
Fluid
Initial Break-in
5,000 miles
(8,000 km)/
200 Hrs
Internal Lube/
Auxiliary
Fluid
Initial Break-in
5,000 miles
(8,000 km)/
200 Hrs
Internal Lube/
Auxiliary
50,000 Miles
(80 000 km)
24 Months/
2000 Hrs
50,000 Miles
(80 000 km)
24 Months/
2000 Hrs
Overhaul 50,000 Miles
(80 000 km)
24 Months/
2000 Hrs
150,000 Miles
240 000 km
48 Months/
4000 Hrs
50,000 Miles
80 000 km
24 Months/
2000 Hrs
Overhaul 50,000 Miles
(80 000 km)
24 Months/
2000 Hrs
3.1.12 Oil And Filter Change Interval
o Oil and Filter Change interval With
Prognostics Mode Disabled
Allison transmissions are factory fill with Castrol
TranSynd
TM
fluid. Oil change must be performed
with the vehicle on a flat and level surface and
with parking brake applied. Oil and oil filter
change frequency is determined by the severity of
service and operating conditions of the
transmission and by the filter equipment installed.
See "TABLE 1, TABLE 2 or TABLE 3" for oil and
filter change intervals. More frequent changes
may be required when operations are subject to
high levels of contamination or overheating.
Filters must be changed at or before
recommended intervals.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the PREVOST X3-45 Multiplex and is the answer not in the manual?

PREVOST X3-45 Multiplex Specifications

General IconGeneral
Length45 ft
Width102 in
EngineVolvo D13
Horsepower500 hp
GVWR54, 000 lbs
Height146 in
Sleeping CapacityVaries based on floor plan
Water CapacityVaries based on floor plan

Related product manuals