PREVOST X3-45 Multiplex User Manual

SECTION 01: ENGINE
PA1562
11
It is important to drain as much oil as possible.
Try to change oil immediately after driving, when
the oil is warm. Always replace the oil filters
when changing the oil.
Component Capacity (L)
Oil pan 24 (min) – 32 (max)
Engine block 1
Filters (3) 6
Total oil fill (empty) 39
NOTE
Since about 1 liter of oil remains in the engine
after draining, approximately 38 liters will be
needed for a complete oil change.
1.3.10 Oil Filters Change
WARNING
Hot oil can cause severe burns. DO NOT
allow hot oil to contact the skin. When
changing oil, wear protective gloves.
CAUTION
Volvo-branded oil filters are designed to
provide the proper level of filtration and
protection for Volvo engines. Filters that do
not meet the same stringent requirements
may cause unsatisfactory results.
• Clean around the oil filter housing and
remove the filters using the oil filter
wrench or the oil filter socket.
FIGURE 5: OIL FILTER WRENCH
• Prefill the new oil filters with approved
engine oil. Also, lubricate the filter gaskets
with engine oil (1). Hand tighten the oil
filters until they contact the sealing surface
of the oil filter housing (2). Manually
tighten the oil filters an additional ¾ to 1
full turn (3).
FIGURE 6: OIL FITER REPLACEMENT
• Start the engine and check for leaks
around the oil filter housing and filters.

PREVOST X3-45 Multiplex Specifications

General

Length	45 ft
Width	102 in
Engine	Volvo D13
Horsepower	500 hp
GVWR	54, 000 lbs
Height	146 in
Sleeping Capacity	Varies based on floor plan
Water Capacity	Varies based on floor plan