PREVOST X3-45 Multiplex User Manual

English 21
Setting the Alarm — (Optional Feature)
To set the Alarm time, do the following:
1 Push MENU (15) button.
2 Push UP (13) or DOWN (17) buttons
until “WAKE UP ALARM” is
displayed.
3 Push OK (14) button to enter the wake
up alarm sub menu.
4 Push UP (13) or DOWN (17) buttons
until “SET TIME” is displayed.
5 Push OK (14) button to enter the set
time sub menu.
6 Push UP (13) or DOWN (17) buttons to
adjust the hours up or down respectively.
7 Push OK (14) button to set the hour and
toggle to the minute adjustment.
8 Push UP (13) or DOWN (17) buttons
to adjust the minutes up or down
respectively.
9 Push OK (14) button to save the time
and finish the process.
Anti Theft Code (Guard)
The radio unit is set to function with only
one vehicle. The Guard feature prohibits
operation of the radio anywhere else. The
Guard is automatic and no manual handling
is normally needed.
In Case of Malfunction
If, by some reason, the radio fails in
detecting the required vehicle, the user will
be prompted to enter the Anti Theft Code
(sticker found in Drivers Handbook). The
display will then show “CODE 0000”.
Note: Please note that this is a malfunction
and should be checked at an authorized
workshop.
To enter the code, do the following:
1 For the current (blinking) digit, turn
the Volume Knob (7) until the right
number is shown.
2 Press the power button to enter the digit.
The next digit will start to blink.
3 Repeat step 1 and 2 until all four digits
has been entered.
The user has three tries to enter the code.
If these are unsuccessful the radio will be
locked for 60 minutes until three new tries
are allowed.

PREVOST X3-45 Multiplex Specifications

General

Length	45 ft
Width	102 in
Engine	Volvo D13
Horsepower	500 hp
GVWR	54, 000 lbs
Height	146 in
Sleeping Capacity	Varies based on floor plan
Water Capacity	Varies based on floor plan