14 English
iPod Mode — (Optional Feature)
The radio supports iPod Classic, iPod Video,
and iPod nano. The iPod settings, e.g.
Shuffle or Repeat, used prior to connecting
the iPod to the radio will be used by the
radio.
Note: An iPod device must be connected
prior to operating in this mode.
Connecting an iPod
Connecting the iPod can be done with two
different cable sets.
1 A split cable from the iPod 30-pin
connector to a USB connector and a 3.5
mm audio connector
2 A separate iPod/USB cable plus a
3.5 mm male/male stereo audio cable
connected to the iPod earphone output
The iPod volume should in this case be set to
maximum prior to connecting to the radio.
When the iPod is connected to the radio, the
iPod’s controls will lock. All control of the
iPod is done by the radio buttons. When
in this state, the iPod will display a Volvo
logotype.
Switching to iPod Mode
There are two ways to switch to iPod mode:
1 Push the CD/AUX (12) button until
“iPod ” shows on the display.
OR
2 Connect an iPod device.
Disconnecting an iPod Device
No special preparations are needed to
disconnect the iPod device. When the iPod
device is removed the radio will play the
previous audio source.
iPod Menu
When iPod is connected and source, the user
can Push and hold the ESC (16 ) button to
enter the iPod Menu. This Menu contains
some of the most common functions used in
the iPod. E.g. the user can search for Artists
and Albums, as well as starting a Playlist.
Push and hold the ESC (16 ) button for 1
second to enter the iPod Menu at last used
level.
Push and hold the ESC (16 ) button for 2
seconds to enter the iPod Menu at top level.
Changing a Track on an iPod
There are two ways to change a track:
1 Push and release the ESC (16 ) or OK
(14) button on the radio to move to the
next or previous track respectively.
OR
2 Using the steering wheel controls: Push
and release the << (21) or >> (20)
button to move to the previous or next
track respectively.
To Next Page
Loading...
Need help?
General
