PREVOST X3-45 Multiplex User Manual

Reinstallation
1. Reinstall any fittings removed prior to disassembly.
2. Reinstall the gear on the input shaft if one was
removed prior to disassembly.
3. Reinstall the retaining nut, if one was removed prior
to disassembly, and torque to manufacturer's
specification.
4. Position the new gasket or o-ring (whichever was
removed) which will seal the pump face to the
mounting surface.
5. Engage the input shaft.
6. Tighten the mounting bolts to manufacturer's
specifications.
7. Unplug and reconnect the input and output lines.
8. Fill the reservoir.
9. Start the vehicle to purge the system.
10. Turn off the vehicle and check the fluid level in the
reservoir. Add fluid as necessary.
11. Bleed the system if necessary using instructions on
the following page.

PREVOST X3-45 Multiplex Specifications

General

Length	45 ft
Width	102 in
Engine	Volvo D13
Horsepower	500 hp
GVWR	54, 000 lbs
Height	146 in
Sleeping Capacity	Varies based on floor plan
Water Capacity	Varies based on floor plan