Application > TN 5250 > User Defined Stp
This option allows you to define your own value (in ASCII characters) for the
User Defined option in the Lead-in Chars menu. “Stp” specifies Stop Code.
See Application > TN 5250 > Lead-in Chars for additional information.
This option only appears if Application > TN 5250 >
Lead-in Chars option is set to “User Defined”.
Application > TN 5250 > Alt. Set 80-9F
This option allows you to choose how data in the range hex 80 through hex
9F is handled.
Prints data in the range of hex 80 through hex 9F.
Interprets data in the range of hex 80 through hex 9F
as control codes.
Application > TN 5250 > Graphic Chek Err
Allows overriding of the host setting for the SGEA (Set Graphic Error Action)
command. For more information about the SGEA command, refer to the
Coax/Twinax Programmer's Reference Manual used on the T5R-ES series.
Ignores the SGEA command from the host. The printer
does not stop when an error is detected; instead, it
substitutes the character selected in the Graphic Chek
Cod parameter.
The host setting for the SGEA used by the printer. If
the SGEA command is requested to stop on graphic
errors, the printer will stop when a graphic error is
detected.
To Next Page
Loading...
