Printronix T6000 - Page 113

113
Application > TN 5250 > Graphic Chek Cod
Specifies the replacement character to print in place of any unprintable
character that is received from the host. Choose a hex character from hex 40
through hex FE. The character becomes the printer default when:
 The printer is powered off and then powered on.
 An SGEA command specifies to use the operator panel default.
 The Graphic Chek Err parameter is disabled.
Minimum
Hex 40
Maximum
Hex FE
Factory Default
60
Application > TN 5250 > Set Text Orientn
Specifies the direction in which characters are printed on the page. This
allows the printer to print languages which are printed right to left instead of
left to right.
Left to Right
Prints characters left to right.
Right to Left
When you select a right to left language, the host will
be notified of print direction changes when the printer
is put ONLINE.
Factory Default
Left to Right
Application > TN 5250 > Host Override
Determines whether the printer accepts certain commands sent by the host,
or continues to use the current menu settings as follows:
 Application > LP+ Setup > Form Width (chars)
 Application > LP+ Setup > Form Length (lines)
 Application > LP+ Setup > Select LPI
 Application > LP+ Setup > Select CPI
 Application > LP+ Setup > Typeface
 Application > LP+ Setup > Text Position
Disable
Allows LP+ host commands to override menu settings
as shown above. Note the information appearing on
the message display may not match the data stream
setting. No values will change upon initial selection of
the Disable option.
Enable
The menu settings override the host commands.
Factory Default
Disable