Application > PGL Setup > Host Form Length
Determines how Media > Image > Label Length is affected upon receiving
an EXECUTE command.
The physical label length will change to match the form
length (specified in CREATE command). The physical
label size remains at the new setting until another
EXECUTE command is received, or the PRINTER
CONTROL menu settings are changed.
The physical label length is the longest element
defined in CREATE mode. Works with
CREATE;NAME;0. This includes all dynamic elements
whether used in EXECUTE mode or not.
The physical label length will change to the longest
print element used in EXECUTE mode plus the setting
of “Var Form Adjust.” Works with CREATE;NAME;0. If
dynamic elements are not used in EXECUTE mode,
they are not included.
Forms printed in EXECUTE mode do not change the
physical label size. Therefore, the size of the form
(defined in CREATE mode) must fit within the current
label dimensions, or errors may be reported.
Changing the form length via the EXECUTE
command changes the LP+ Emulation logical
dimensions.
Application > PGL Setup > Var Form Adjust
This specifies an amount (in tenths of inches) to add to the length of
variable- length forms. Variable-length forms use a semicolon at the end of
the CREATE command: ~CREATE;<FORMNAME>;0.
Typically, variable-length forms are determined by the elements within the
form. The longest form element becomes the overall form length. This option
allows an additional space to be added to the form length.
To Next Page
Loading...
