Application > VGL Setup > Slash 0
This parameter allows you to print the numeral “0” with or without the slash.
This option applies to all character sets except OCR A and OCR B.
Zero is printed without a slash.
Zero is printed with a slash.
Application > VGL Setup > Repeat Form
When enabled, this menu speeds up the label printing for repeated form. This
only applies to forms where the entire form is enclosed in the command:
^IREPV...^IREPE
Should be selected when subsequent forms are
unrelated to one another.
Speeds up the processing of repeated forms, thereby
resulting in increased printer throughput. This option
provides no speed benefit for forms that are unrelated
to one another and should be disabled under those
circumstances.
Application > VGL Setup > Ignore Dots
Controls how VGL interprets position values.
The VGL expects position values to be specified in
tenth inches and dot rows.
Causes the VGL to expect position values to be
specified in only 1/10ths of an inch. If the dot position is
also given, it is treated as text.
To Next Page
Loading...
