Printronix T6000 - Page 143

143
Application > LP+ Setup > Form Width (xx)
Specifies form width in three different units for all preferences of the user:
inches, millimeters, and even characters.
Minimum
0.1 inches
Maximum
T6x04: 4.1 inches
T6x06: 6.6 inches
Factory Default
The maximum printing width based on model.
IMPORTANT
Only characters are available when the TN5250 is
enabled.
WARNING
The width should not exceed the actual paper
width to prevent damage to the platen.
Application > LP+ Setup > Left Margin
Set in characters. Character zero is defined as the far left edge of the page,
and column numbering increments from left to right.
Minimum
0 characters
Maximum
369 characters
Factory Default
0 characters
IMPORTANT
This menu is hidden when TN5250 is enabled.
Application > LP+ Setup > Right Margin
Set in characters. Character zero is defined as the far right edge of the page,
and column numbering increments from right to left.
Minimum
0 characters
Maximum
369 characters
Factory Default
0 characters
IMPORTANT
This menu is hidden when TN5250 is enabled.