Printronix T6000 - Page 259

259
Table 13. LCD Message Troubleshooting
Displayed Message
Solution/Explanation
PRINT HEAD HOT
The printhead has become overheated.
1. Allow the printhead to cool down for 5 minutes, then press
PAUSE. Resume printing.
2. If possible, reduce print intensity.
3. If problem persists, contact your authorized service
representative.
PRINT HEAD UP
Close Print Head
Printhead is not closed and completely latched.
1. Close and latch the printhead pivoting deck.
PRINTER HOT
The printer has detected higher than usual temperatures on the
controller PCBA.
1. Determine that the fan is operating and that all air vents are
unobstructed.
2. Power off the printer for 15 seconds, then power the printer
back on.
3. Move the printer to a cooler location.
4. If the problem persists after moving the printer to a
cooler location, contact your authorized customer
service representative.
PRINTER UNDER
REMOTE CONTROL
Indicates that PNE has control of the printer.
1. Press any key on the printer.
PROGRAMMING 1284
OPTION CARD
---------------------
DO NOT POWER OFF
Status Message indicating that the IEEE1284 option card FPGA is
being programmed. This process will take less than 60 seconds to
complete and a message will be displayed when completed.
PROGRAMMING GPIO
OPTION CARD
---------------------
DO NOT POWER OFF
Status Message indicating that the GPIO option card FPGA is
being programmed. This process will take less than 30 seconds to
complete and a message will be displayed when completed.
PWR SUPPLY HOT
Power supply is hot.
1. Determine that the fan is operating and that all air vents are
unobstructed.
2. Move the printer to a cooler area.
3. If the problem persists, contact your authorized
customer service representative.