Printronix T6000 - Page 284

284
Table 27. General PTX_SETUP Commands
Command
Sub-Command
Parameter
Description
CONFIG
PRINT
Cfg
Print Configuration Cfg. Cfg can be
a number 1-8, or one of four pre-
defined configurations. The four
non-numeric configurations are
requested using the first character
for the CURRENT, FACTORY,
POWERUP, or ALL configuration(s).
DELETE
Cfg
Deletes Configuration number Cfg.
Cfg must be in the range of 1-8.
UPLOAD
Port;Cfg
This command uploads the
configuration stored in location Cfg
to the port specified by Port. Port
must either be 1284 or SERIAL. Cfg
may be 1-8 or ALL.
DOWNLOAD
Cfg
This command saves the
configuration data that follows as
configuration Cfg. Cfg must be 1-8
or END.
OVERLAY
Cfg
This command overlays the
configuration data that follows on
existing configuration Cfg. Cfg must
be 1-8 (or END). If Cfg does not
exist then command is treated the
same as DOWNLOAD.
RESET
Reboots the printer.
GET_NAMES
“Port”
This command uploads the names
of the configurations to the port
specified by Port. Port must either
be “1284” or “SERIAL”.
SET_NAME
Cfg
This command downloads a name
for the configuration specified by
Cfg. Cfg must be 1-8.
CLEAR_NAMES
This command resets all of the
configuration names to their default
values.
MPI_SELECT
MPI
This command selects the active
Management Protocol Interface
(MPI). Currently there are two
selections “UCP” and “PXML”.