Psion Teklogix 7035 - Page 114

Chapter 4: Tekterm
802.IQv1 Radio Statistics Screen
88
Teklogix 7035, 8255 & 8260 Terminals User Manual
• xi number of initializations with the network controller.
• ra number of received acknowledgements. (Normally, this
number should match the value in
xm.)
• xa number of transmitted acknowledgements. (Normally, this
number should match the value in
rm.)
• bt beacon timeouts. Number of times the beacon has not been
received as expected.
• xr number of retransmissions. This number should remain low
if radio coverage is adequate.
• rt average round trip time. This number represents the millisec-
onds taken to send a message and receive a response from the
the base station.
• va variance of the round trip time.
• Address Info this information is most useful then the terminal is configured
using auto radio address and/or auto terminal number. In this
case, two sessions are configured – one ANSI and one TESS.
(The SNMP session is established automatically.)
• MAC ADDR the MAC address of the radio card installed in the terminal.
• Serial NO terminal serial address.
• SysName corresponds with the “Name” configured in the SNMP menu.
• GroupName corresponds with the “Group Name” configured in the
SNMP menu.