Teklogix 7035, 8255 & 8260 Terminals User Manual 123
Chapter 7: Setting Parameters
Caps Lock On
Rate
The value assigned for the “Rate” parameter determines how quickly the key you
press repeats and is measured in characters per second (cps). The allowable values
range from
1 cps to 10 cps.
Test
This parameter is provided so that you can test the character repeat rate of your
terminal. Once you’ve enabled (set to “Y”) the “Typematic rpt” parameter and
assigned a “Delay” and “Rate” value, position your cursor in this field. Press and
hold down an alphanumeric key to test the rate of character repeats.
7.5.5 Caps Lock On
This parameter operates like the <CAPS LOCK> key on your PC keyboard. When
“Caps Lock On” is set to “Y”, all alpha characters are displayed in uppercase. When
this parameter is set to “N”, alpha characters are displayed in lowercase.
7.5.6 Panning
Important: The “Auto Pan” feature is modified using the parameters in this
menu. Keep in mind, however, that “Auto Pan” is used by the
DOS command line or by applications that do not provide auto
panning (e.g., the Parameters menus).
Tekterm is equipped with its own panning capabilities and does
not execute panning as described in this section.
Auto pan y Y/N
Left margin 5 0-25
Right margin 1 0-25
Bottom margin 1 0-20
X increment 1 0-25
Y increment 1 0-25
Range
Panning
To Next Page
Loading...