Chapter 7: Setting Parameters
Typematic Rpt
122
Teklogix 7035, 8255 & 8260 Terminals User Manual
Lock
When the Lock option is selected, the modifier key is locked ‘on’ after being
pressed only once. The key remains ‘on’ until it is pressed a second time to turn it
off.
Note: When a modifier key is locked ‘on’, it is displayed in uppercase letters in
the status area at the bottom of the terminal screen.
1 Shot
When 1 Shot is selected, the modifier key remains on only until the next key is
pressed.
Note: A modifier key cannot be locked ‘on’ when 1 Shot is selected.
1 Shot/Lock
When 1 Shot/Lock is selected and a modifier key is pressed once, the modifier
key remains ‘on’ only until the next key is pressed.
If the modifier key is pressed twice, it remains locked ‘on’ or active until it is
pressed a third time to turn it off.
Note: When a modifier key is locked ‘on’, it is displayed in uppercase letters in
the status area at the bottom of the terminal screen. Otherwise, it is dis-
played in lowercase characters.
7.5.4 Typematic Rpt
When this parameter is enabled (set to “Y”), pressing and holding down an
alphanumeric key will cause that character to repeat until the key is released.
Delay
The value assigned for this parameter determines the delay in milliseconds between
repeat characters. The allowable values are:
150 ms, 200 ms, 250 ms, 300
ms, 350 ms, 400 ms, 450 ms
and 500 ms.
Delay 500 ms see text
Rate 5 cps 1 cps..10 cps
Test see text
Range
Typematic rpt
To Next Page
Loading...