Chapter 7: Setting Parameters
Watchdog Timer
128
Teklogix 7035, 8255 & 8260 Terminals User Manual
The values on the left-hand side of the “Palette Remap” screen represent the original
VGA palette; these values cannot be changed. The values on the right-hand side of
this screen can be altered to remap colours as they reach your Teklogix terminal
display. For example, suppose that you want your terminal to always replace the
colour red with the colour black. You need to change the red colour value of 4 to
the black colour value of 0.
To remap a colour:
• Highlight the colour you want to remap, and press the <RIGHT> or
<LEFT> arrow key until the colour value you want is displayed.
• Press <F4> to save your changes, and reset the terminal. (See page 117 for
terminal reset information.)
7.5.11 Watchdog Timer
Setting this parameter to Enabled signals the terminal to reboot automatically
when control of the terminal is not periodically returned to a system monitor
program (running in the background). This allows for recovery from programs that
“crash” or “hang” the terminal.
If “Watchdog Timer” is set to
Disabled, the terminal will not reboot
automatically under the circumstances described above.
[0] Black [0]
[1] Blue [1]
[2] Green [2]
[3] Cyan [3]
[4] Red [4]
[5] Magenta [5]
[6] Brown [6]
[7] Lt Grey [7]
[8] Dark Grey [8]
[9] Lt Blue [9]
[a] Lt Green [a]
[b] Lt Cyan [b]
[c] Lt Red [c]
[d] Lt Magenta [d]
[e] Yellow [e]
[f] White [f]
Palette Remap
To Next Page
Loading...