Teklogix 7035, 8255 & 8260 Terminals User Manual 141
Chapter 7: Setting Parameters
UPC A
7.6.3.5 UPC A
Inc Num Sys
If this parameter is enabled (set to “Y”), the number system digit is included with
the decoded bar code data.
Include Chk
If this parameter is enabled (set to “Y”), the check digit will be included with the
decoded bar code data.
Size/Chars
See “Size/Chars” beginning on page 139.
Addendum
Important: Before “Addendum” can take effect, the “Short Code” parameter
in the Options menu (see page 133) must be set to “Y”.
Refer to “Addendum” on page 140.
7.6.3.6 UPC E
Exp to UPC A
Setting this parameter to “Y” enables a non-standard decoding that returns 12 digits
from the 6 digit UPC E bar code.
Inc Num Sys N
Include Chk N
Size/Chars »
Addendum Disabled
UPC A
Exp to UPC A Y
Inc Num Sys Y
Include Chk Y
Size/Chars »
Addendum Disable
UPC E
To Next Page
Loading...