Teklogix 7035, 8255 & 8260 Terminals User Manual D-21
Appendix D: Radio Parameters
WLAN Timing
D.4.2 WLAN Timing
Reinit tmo
“Reinit tmo” controls how soon a terminal sends a warm initialize message to the
controller when a cellular acknowledgement is not received for a previously sent
message. This parameter operates in units of seconds and is set to 10 by default.
D.4.3 Power Saving
PwrON time
This parameter is used in conjunction with “PwrOFF time” to control the duration
of time the radio stays on after a message is sent (twice this period if application
data is sent). “PwrON time” is in units of 1/2 seconds. The range is 0 to 20 and
increases the radio on time in increments of 0.5 seconds. “PwrON time” should be
set from 8 to 20 for 902 MHz radios.
Important: Using power saving in Wireless LAN will affect system perfor-
mance since terminals cannot receive routing information when
the radio is turned off, and will thus be slower to hop to new
routes. Therefore, the “PwrON time” parameter should not be set
lower than 5.
Reinit tmo 10 5-20
Range
WLAN Timing
PwrON time 0 0-20
PwrOFF time 0 0-20
PwrON xmit 0 1-20
Power Saving
Range
To Next Page