Psion Teklogix 7035 - E.2 Loading AirFortress Secure Client Software

Appendix E: AirFortress™ Secure Client
Loading AirFortress™ Secure Client Software
E-2
Teklogix 7035, 8255 & 8260 Terminals User Manual
E.2 Loading AirFortress™ Secure Client Software
The AirFortress™ driver and configuration tool must be installed on the writable
drive of the 7035 using a Psion Teklogix serial cable or console cable.
Note: Although either type of cable can be used, a serial cable is recommended.
• Exit to DOS. (If you are running Tekterm, press <ALT> and type x.)
• Choose ‘DOS prompt’ from the startup menu, and enter your password.
• At the DOS prompt, type a: to change the default drive to A:
At the A: drive:
• Run the upload utility on the 7035 ymodem.
If you are using a serial cable:
• Type y to start the ymodem program at 57600 baud.
• Configure your terminal emulator program for a rate of 57600
• Use your terminal emulator program ymodem ‘send’ function to send the
AirFortress™ driver,
fsdrvr.exe.
• Repeat the procedure for the configuration utility,
fscfg.exe.
If you are using a console cable, the terminal emulator should be set to 4800 bps.
• Type ymodem -y4800:2 and upload the file from your terminal emulator
using the ymodem ‘send’ function.
When the files have successfully uploaded:
• Reboot the terminal, exit to DOS and run
fscfg to configure your system
access ID.