Teklogix 7035, 8255 & 8260 Terminals User Manual E-3
Appendix E: AirFortress™ Secure Client
Launching And Setting Up AirFortress™ Secure Client
E.3 Launching And Setting Up AirFortress™ Secure Client
To launch AirFortress™:
• Type fscfg.
A menu of options is displayed.
1. Change password
2. Change access ID
3. Toggle encryption
4. Reset connections
5. Diagnostics
6. Quit
E.3.1 Assigning A Password
The password for AirFortress™ is set to sysadm by default. It is important that you
assign your own password – one that you can easily remember but that is not
obvious to anyone else. Write your password on a piece of paper, and keep it in a
secure place.
• Choose ‘Change Password’ from the startup menu.
• In the New Password field, type your new password, press <ENTER>.
• In the Confirm Password field, type your password again.
A message indicates that the change was successful.
• Press the ‘M’ key to return to the menu.
E.3.2 Changing Device Access ID
The same access ID must be assigned to every device communicating on the
network. This ID is a 16-digit hexadecimal value that identifies and either allows or
denies access to a particular device. 7035 terminals with the AirFortress driver
installed can only communicate with AirFortress Gateways (AF1100) that have the
same access ID.
To change the access ID:
• Choose ‘Change Access ID’ from the startup menu.
• Type the current access ID, and press <ENTER>. (If AirFortress™ has
never been configured, type default.)
To Next Page