Teklogix 7035, 8255 & 8260 Terminals User Manual 159
Chapter 7: Setting Parameters
TESS Settings
Exclusive
ANSI sessions can be configured to receive all serial input, even if they are not the
currently active session. To send data to a single session, the ‘Exclusive’ parameter
must be set to ‘Y’. If more than one session has the ‘Exclusive’ parameter enabled,
the session with the largest application number (1-4) receives the serial input. The
other(s) do not see any serial input.
Start/End
The start character is added to the beginning of the data received from the serial
(async) port. The end character is added to the end of the data received.
7.7.2 TESS Settings
Each session you create has its own “Settings” parameters. Additional TESS
information is documented in Chapter 5: TESS Operations.
Auto Term#
Note: Refer to “Group” on page 160 for additional instructions.
When this parameter is set to “Y”, a unique terminal number is assigned for the
current TESS session. If “Auto Term#” is set to “Y”, any value assigned to the
“Terminal #” parameter is ignored.
Note: “Auto Term#” is available when
802.IQv2 is assigned to the “Host
Conn” parameter (page 160) or when
802.IQv1 is enabled in the Radio
Menu (“802.IQ v1” on page D-6).
Auto Term# Y» see text
Terminal # 1 see text
Host Conn » see text
Screen » see text
Characters » see text
Serial » see text
Tests » see text
Scanner » see text
Fields » see text
Features » see text
TESS
Range
To Next Page