Psion Teklogix 7035 - Power - 7035 Only; Serial Number

To Next Page

To Previous Page

Teklogix 7035, 8255 & 8260 Terminals User Manual 129

Chapter 7: Setting Parameters

Power – 7035 Only

7.5.12 Power – 7035 Only

CPU Speed

Important: Changing the CPU speed can invalidate FCC approvals. Cisco

and Lucent radios are approved for 33Mhz. The Narrow Band

radio is only approved for 8 MHz.

This parameter allows you to change the CPU speed your terminal uses. Allowable

values are:

8MHz, 16MHz and 33MHz.

Power Down

When the amount of time speciﬁed in the “Power Down” parameter expires without

any activity, the terminal goes into suspend mode, a power-saving mode. Pressing

<ENTER/ON> reinstates full power mode.

The possible values for this parameter are:

Disabled, 1 min, 2 mins,

4 mins, 8 mins, 16 mins, 32 mins and 60 mins.

Power Off

Important: The value assigned for this parameter is not recognized until the

value in the “Power Down” parameter has expired.

When the time speciﬁed for the “Power Off” parameter has expired, the terminal

turns off. A full reboot is required to return the terminal to full operating mode. The

allowable values for this parameter are:

Disabled, 1 min, 8 mins, 16

mins, 32 mins, 1 hour, 2 hours and 4 hours.

This timeout occurs whether the terminal is turned on or off. That is, even if the

terminal is switched off, it will return to its last operating state when switched on. If

it is left ‘off’ for the time period speciﬁed by this parameter, a full reboot will occur

when switched back on.

7.5.13 Serial Number

This parameter identiﬁes the terminal serial number. Normally, this value is set at

the factory. However, the serial number can also be deﬁned in the ﬁeld using a serial

download cable and a terminal connection to PMENU.

Note: “Serial Number” is saved in EEPROM; it will not be erased if the

parameter values are defaulted.

CPU speed 33MHz 8, 16, 33MHz

Power down 4 mins see text

Power off 1 hour see text

Range

Power