Teklogix 7035, 8255 & 8260 Terminals User Manual 27
Chapter 2: Assembly And Basic Operation
Launching And Exiting Tekterm
2.6.1.3 Launching And Exiting Tekterm
Normally, the Tekterm application – an emulation – is automatically launched when
the terminal is turned on. If the “Display Menu” is on your screen:
• Type the letter b to launch Tekterm.
To exit Tekterm and return to the “Display Menu”:
• Press <ALT> and type the letter x.
2.6.1.4 Launching And Exiting DOS
To launch DOS from the “Display Menu”:
• Type the letter c.
At this point, you’ll be asked to enter a password – either a supervisory or Teklogix
level password.
To exit DOS and return to the “Display Menu”:
• Type start at the DOS prompt. Press <ENTER>, and then press
<ESC> immediately.
To exit DOS and return to the “Emulations” screen:
• Type start at the DOS prompt, and press <ENTER>.
2.7 The Keyboard
Teklogix offers a variety of keyboards for the 7035 hand-held and the 8255 and
8260 vehicle-mount terminals. All keyboards are equipped with a set of keys
standard across all keyboards. These are described in “Keyboard Keys – A
Description” beginning on page 48.
Accessing additional keys such as alpha keys, function keys and macro keys varies
slightly depending on the type of terminal and keyboard used. A description of each
type of keyboard and the methods used to access these keys is outlined in
Chapter 3: Keyboards – Operating Instructions beginning on page 57.
To Next Page
Loading...