Chapter 7: Setting Parameters
Host Conn
160
Teklogix 7035, 8255 & 8260 Terminals User Manual
Group
When “Auto Term#” is set to “Y”, the ‘Group’ parameter is used to identify the
group or pool of terminal numbers from which an auto-address is chosen.
Terminal #
For every application session you create, the terminal number assigned in the
“Terminal #” parameter must be non-zero and unique. This parameter defines the
terminal number for the TESS session and uniquely identifies all transmissions to
and from the terminal.
Other applications running in the terminal, such as an ANSI session or another
TESS session must each have a different terminal number. In addition, each
Teklogix terminal using the radio link must have a unique terminal number.
7.7.2.1 Host Conn
Important: This parameter is not available when the terminal is operating
with a narrow band radio.
Conn Type
The options for this a parameter vary depending on the type of application you are
running – ANSI or TESS.
For TESS applications, this parameter allows you to choose one of the following
types of connections:
802.IQv2 or 9010t (TCP Direct). In either case, the
terminal will be communicating through a controller or an SDK. (For details about
ANSI options, review “Host Conn” on page 148.)
Group 1 1-5
Range
Auto Term#
Conn Type 802.IQv2 802.IQ, 9010t
Settings » see text
Range
Host Conn
To Next Page