Chapter 7: Setting Parameters
Fields
170
Teklogix 7035, 8255 & 8260 Terminals User Manual
Rjct if Alpha
When the cursor is in a numeric field and “Rjct if Alpha” is enabled (set to “Y”),
bar codes containing alphabetic characters are rejected.
Beam Lockout
When enabled (set to “Y”), this parameter disallows scanner use when the current
session is in “LOCK-H” mode.
7.7.2.7 Fields
Field Order
This parameter determines the mode of cursor movement between fields. The next
field can be defined by location on the screen or by the assignment of field numbers.
When enabled (set to “Y”), the cursor moves according to field location. If disabled
(set to “N”), the cursor moves according to the numeric order of the fields.
Enter To F0
The <ENTER> key normally enters data into a field and moves the cursor to the
next field. However, some applications require that the <ENTER> key start a
transmission from the terminal. When enabled (set to “Y”), this parameter causes
the <ENTER> key to be interpreted as <F0> which starts a transmission.
Enter On Arr
When this parameter is enabled (set to “Y”), the arrow keys can be used to complete
data entry into a field.
Field Order Y Y/N
Enter To F0 Y Y/N
Enter On Arr Y Y/N
Entry Mode field see text
Open Fky Only N Y/N
Video » see text
All Fld Video Y Y/N
Ign Bcode_fld N Y/N
Enh Edit Mode N Y/N
Valid Numerics +-%*/.,$ see text
Range
Fields
To Next Page
Loading...