Chapter 7: Setting Parameters
Keyboard Type – Vehicle-Mounts Only
130
Teklogix 7035, 8255 & 8260 Terminals User Manual
7.5.14 Keyboard Type – Vehicle-Mounts Only
Teklogix offers two types of vehicle-mount keyboard types – an ‘F1 To F6’ and an
‘F1 to F10’ keyboard type. The keys on these two keyboard are mapped differently,
and the ‘Keyboard Type’ parameter allows you to specify the keyboard type your
terminal is using – ‘F1 To F6’ or ‘F1 to F10’.
Note: The value assigned to this parameter is saved until you change it; that is,
it will not change when the <F3> – Default – key is pressed.
7.6 Scanner
7.6.1 Type
The Type sub-menu is used to indicate the type of internal and/or external scanner
being used. The 7035 hand-held terminal can support both an internal and an
external scanner at the same time.
Internal – 7035 Only
Note: If you are using an Advanced Long Range (ALR) scanner, choose the
Long Range setting. If you are using an High Performance (HP)
scanner, choose either the
Standard or High Visibility setting.
Keep in mind also that if you are using a
2-D scanner, ‘Console 2’ in the
Ports menu is set to ‘Disable’ by default – it cannot be configured.
The “Internal” parameter must match the type of internal scanner installed in the
7035 –
Long Range, High Visibility, Standard or 2-D. If an internal
scanner has not been installed, set this parameter to
None.
Type »
Options »
Barcode »
Scanner
Internal Standard Standard, Long Range, High Vis, 2-D
External Non-Decoded Non-Decoded, Wand
Range
Type
To Next Page