Psion Teklogix 7035 - Tekterm Exit Password; ANSI FK Remap

Teklogix 7035, 8255 & 8260 Terminals User Manual 195
Chapter 7: Setting Parameters
Tekterm Exit Password
7.16.3 Tekterm Exit Password
When this parameter is set to ‘Y’, the user is prompted to enter a password before
being allowed to exit the Tekterm application.
7.17 ANSI FK Remap
In ANSI, each function key – <F1> to <F36> – has a default string associated with
it. When a function key is pressed, the corresponding default string is sent to the
host. The “ANSI FK Remap” table allows these function key character sequences to
be redefined. The remapped string length is limited to a maximum of 7.
Important: This menu is available only after the “FK Remap” parameter
(see “FK Remap” on page 151) is set to “Y”.
Exit Password N Y/N
Tekterm
Range
F 1 = 1b 4f 50 00 see text
F 2 = 1b 4f 51 00
F 3 = 1b 4f 52 00
•
•
•
F28 = 1b 5b3432
F29 = 1b 5b3433
F30 = 1b 5b3434
ANSI FK Remap
Range