Teklogix 7035, 8255 & 8260 Terminals User Manual 155
Chapter 7: Setting Parameters
Transmit
Note: When an 8-bit set is selected from the ‘Lower’ character set, the ‘Upper’
character set cannot be changed.
To choose ‘Lower’ and ‘Upper character sets:
• Position the cursor on the ‘Lower’ or ‘Upper’ parameter, and press the
<RIGHT> or <LEFT> arrow key to display the character set options.
• Press <F4> to save your selection to memory.
Important: When a character sent from the host cannot be displayed, a
rectangular box is used as a substitute.
7.7.1.4 Transmit
Xmit Count
This parameter determines how many characters from the keyboard or scanner are
buffered by the terminal before being transmitted to the host. If 0 (zero) is selected,
the terminal transmits only according to the “Xmit Wait” parameter. If the ANSI
block mode features are used, this parameter should be set to 99.
Note: If the terminal is not in local edit mode, the <ENTER>, arrow, <CTRL>,
and function keys cause an immediate radio transmission regardless of
the “Xmit Count” parameter setting.
Xmit Wait
This parameter determines the length of time the terminal collects keystrokes before
transmitting them to the host. This value is specified in increments of one 10th of a
second (i.e., a value of 10 represents 1 second). If 0 (zero) is selected, the terminal
transmits only according to the “Xmit Count” parameter.
Note: If the terminal is not in local edit mode, the <ENTER>, arrow, <CTRL>,
and function keys cause an immediate radio transmission regardless of
the “Xmit Wait” parameter setting.
Xmit Count 99 0-99
Xmit Wait 1 0-999
Dev Attr see text
Auto-Answer see text
7 Bit Y Y/N
Range
Transmit
To Next Page
Loading...