Chapter 7: Setting Parameters
Code 128
138
Teklogix 7035, 8255 & 8260 Terminals User Manual
7.6.3.2 Code 128
Type
When using Code 128, you can choose the type of bar code variation the scanner
will recognize. The options available are
Standard, UCC and EAN/UCC. These
options are described below.
Standard
Set “Standard” to “Y” if Code 128 is desired.
UCC
“UCC” is a variation of Code 128.
EAN/UCC
Set “EAN/UCC” to “Y” to enable this type of bar code. “EAN/UCC”
bar codes include group separators and start codes.
Include Sym
Enabling (setting to “Y”) “Include Sym” causes the group separator(s) and start
code contained in this type of bar code to be displayed on the terminal screen.
Size/Chars
See “Size/Chars” on page 136.
7.6.3.3 EAN 13
Inc Country
If this parameter is enabled (set to “Y”), the country code is included with the
decoded bar code data.
Type Standard
Include Sym N
Size/Chars »
Code 128
Inc Country Y
Include Chk Y
Size/Chars »
Addendum Disabled
EAN 13
To Next Page