Teklogix 7035, 8255 & 8260 Terminals User Manual 139
Chapter 7: Setting Parameters
EAN 13
Include Chk
If this parameter is enabled (set to “Y”), the check digit is included with the decoded
bar code data.
Size/Chars
Prefix Char
This character, if non-zero, is added before a successfully decoded bar code. Enter
the ASCII decimal value of this character from 0 to 255. Enter a value of “0” (zero)
if no prefix is to be added.
Suffix Char
This character, if non-zero, is added after a successfully decoded bar code. Enter the
ASCII decimal equivalent of this character from 0 to 255. Enter a value of “0” (zero)
if no suffix is to be added.
Strip Leading
This parameter determines the number of characters that will be removed from the
beginning of the bar code before the prefix character is added.
Notes: 1. The appended character is treated as any other keyboard character.
For example, if <DEL> is pressed, the usual action for that key is
performed. With ANSI emulation, the terminal transmits the escape
sequence associated with the function immediately after the bar
code data.
2. For Code 39 bar codes, the “AIAG Strip” is performed before the
“Strip Leading”.
Strip Trailing
The value entered in this parameter determines the number of characters that will be
removed from the end of the bar code before the suffix character is added.
Prefix Char 0 0-255
Suffix Char 0 0-255
Strip Leading 0 0-127
Strip Trailing 0 0-127
Size/Chars
Range
To Next Page