Teklogix 7035, 8255 & 8260 Terminals User Manual 147
Chapter 7: Setting Parameters
ANSI Settings
7.7.1 ANSI Settings
Each session you create has its own “Settings” parameters. Additional ANSI
information is documented in Chapter 6: ANSI Operations.
Auto Term#
Note: Refer to “Group” on page 147 for additional instructions.
When this parameter is set to “Y”, a unique terminal number is assigned for the
current ANSI session. If “Auto Term#” is set to “Y”, any value assigned to the
“Terminal #” parameter is ignored.
Note: “Auto Term#” is available when 802.IQv2 is assigned to the “Host
Conn” parameter (page 148) or when
802.IQv1 is enabled in the Radio
Menu (“802.IQ v1” on page D-6).
Group
When “Auto Term#” is set to “Y”, the ‘Group’ parameter is used to identify the
group or pool of terminal numbers from which an auto-address is chosen.
Auto Term# Y» see text
Terminal # 1 1-1024
Host Conn » see text
Screen » see text
Host Char Set » see text
Transmit » see text
Keyboard » see text
Serial » see text
Ansi
Range
Group 1 1-5
Range
Auto Term#
To Next Page
Loading...