Teklogix 7035, 8255 & 8260 Terminals User Manual 193
Chapter 7: Setting Parameters
7035 Hand-Held ‘Sound’ Parameter Values
7.15.2 7035 Hand-Held ‘Sound’ Parameter Values
Beep Tone And Beep Time
These parameters regulate the frequency and duration of beeps emitted in a TESS or
ANSI session when one of the following is received at the terminal: an advisory, a
hey you or a bell character. Tone is measured in hertz and time in milliseconds.
Error Tone And Error Time
These parameters determine the frequency and duration of each error tone. Tone is
measured in hertz and time in milliseconds.
Scan Tone 1 And Scan Time 1
“Scan tone 1” and “Scan time 1” determine the frequency and duration of the first
beep of a multiple beep. Tone is measured in hertz and time in milliseconds.
Scan Tone 2 And Scan Time 2
“Scan tone 2” and “Scan time 2” determine the frequency and duration of the
second beep of a multiple beep. Tone is measured in hertz and time in milliseconds.
Scan Tone 3 And Scan Time 3
“Scan tone 3” and “Scan time 3” determine the frequency and duration of the third
beep of a multiple beep. Tone is measured in hertz and time in milliseconds.
Beep tone 4300 500-5000
Beep time
600 0-2000
Error tone 3000 500-5000
Error time 600 0-2000
Scan tone 1 2600 500-5000
Scan time 1 150 0-2000
Scan tone 2 3300 500-5000
Scan time 2 150 0-2000
Scan tone 3 4750 500-5000
Scan time 3 150 0-2000
Sound
Range
To Next Page