Teklogix 7035, 8255 & 8260 Terminals User Manual 117
Chapter 7: Setting Parameters
Saving Changes To Parameters
7.3.7 Saving Changes To Parameters
Whenever a parameter value is altered, the new value must be saved. To do this:
• Press <F4> – the “SAVE” function key.
If a parameter value is changed and the menu exited before the change is saved, a
dialog box appears asking whether or not the operator wants to save the changes.
7.3.8 Resetting The Terminal
Note: Regardless of the type of terminal you are using, a reset will result in a
complete reboot of the unit. When the terminal is reset, it reboots to the
Tekterm application and parameter changes take effect.
7.3.8.1 Resetting The 7035
To reset a 7035:
• Press and hold down the <BLUE> key and the <ENTER/ON> key for a
minimum of six seconds.
7.3.8.2 Resetting The 8255 And 8260
To reset an 8255 or 8260:
• Using the On/Off switch, turn the terminal off and back on again.
7.3.9 Resetting Parameters To Default Values
Important: When <F3> – the DEFAULT key – is pressed, all parameter
values revert to the factory defaults, including those values that
you’ve changed and saved.
• Press <F3> – the “DEFAULT” function key – to reinstate the default
parameter values.
• Press <F4> – the “SAVE” function key – to save the changes.
• Reset the terminal. See "Resetting The Terminal" above.
To Next Page
Loading...