Psion Teklogix 7035 - Resetting Radio Statistics; Exiting Tekterm

To Next Page

To Previous Page

Chapter 4: Tekterm

Resetting Radio Statistics

Teklogix 7035, 8255 & 8260 Terminals User Manual

802.IQv2 Radio Statistics

With only a few differences (outlined below), the next sections of the screen –

802.IQ Statistics and Address Info – follow the same format as 802.IQv1

statistics. Refer to the section titled "802.IQv1 Radio Statistics Screen" beginning

on page 87 for a description of the 802.IQv2 statistics.

The differences in 802.IQv2 are as follows:

• AP/Controller This replaces AP MAC – there is only one 802.IQv2

network controller. The access point the terminal is

associated with is not indicated.

• rt Round trip time is the total time taken to communicate

with the controller through the access point and across the

network infrastructure and back.

• Address Info 802.IQv2 always use automatic radio addresses. The

radio address assigned is displayed here. Automatic

terminal numbering is optional, but all sessions are listed

here.

4.5 Resetting Radio Statistics

To reset the radio statistics to 0 (zero):

• Type the letter z.

4.6 Exiting Tekterm

To exit Tekterm:

• Press <ALT> and type x.

When you exit Tekterm, the “Display Menu” described in “Launching Tekterm” on

page 83 appears on the terminal screen.