Chapter 2: Assembly And Basic Operation
Beeper Volume – <BLUE> <F3> And <F4>
32
Teklogix 7035, 8255 & 8260 Terminals User Manual
There are two ways to adjust the beeper volume – by pressing the <BLUE>
key in combination with <F3> and <F4> or by assigning a value in the
“Volume” parameter. Both are described in the sections directly following.
2.8.6.1 Beeper Volume – <BLUE> <F3> And <F4>
Important: When you adjust the beeper volume using the <BLUE> <F3> and
<F4> key combination, the new setting is not saved to memory.
If the terminal is shut off and powered up again, the volume
adjustment is lost.
When you adjust the volume using the “Volume” parameter, the
change is saved to memory.
The beeper volume can be adjusted using the <BLUE> key in combination with
function keys <F3> and <F4>.
To increase the beeper volume:
• Press the <BLUE> key and then, press the <F3> key. Repeat this key
combination until the volume is sufficient for your needs. To work more
efficiently with these keys, refer to the note below.
To decrease the beeper volume:
• Press the <BLUE> key and then, press the <F4> key. Repeat this key
combination until the volume is low enough for your needs. To work more
efficiently with these keys, refer to the note below.
Note: To more efficiently adjust the beeper volume, lock the <BLUE> key “on”
by pressing it twice. You can then press the <F3> or <F4> function keys
until the beeper volume suits your needs.
When you have satisfactorily adjusted the beeper volume, press the
<BLUE> key a third time to unlock or turn it off.
To Next Page
Loading...