Chapter 7: Setting Parameters
Radio
192
Teklogix 7035, 8255 & 8260 Terminals User Manual
Batt Thresh
Note: This parameter is only available when the Teklogix security password is
entered at startup. (‘Allow Teklogix’ must be set to “Y” – see page 194).
The SNMP agent periodically polls the battery level and compares the level to the
value assigned as the low battery threshold – “Batt Thresh. If the battery level is
lower than the value assigned to the “Batt Thresh” parameter, a trap is sent only
once until the battery level increases – presumably, when the battery has been
replaced. This parameter is set to ‘0’ (zero) by default.
CQ Thresh
Note: This parameter is only available when the Teklogix security password is
entered at startup. (‘Allow Teklogix’ must be set to “Y” – see page 194).
The SNMP agent polls the channel quality on a periodic basis and compares it to the
value assigned as the low channel quality threshold – “CQ Thresh”. If the channel
quality is lower than this threshold, a trap is sent only once until the channel quality
increases to a recovery level. This parameter is set to ‘0’ (zero) by default.
7.14 Radio
Refer to Appendix D: Radio Parameters for a detailed description of the parameters
used to adjust radio communications.
7.15 Sound
Note: The default values for “Beep tone”, “Error tone” and “Scan tone1, 2 and
3” vary between 7035 hand-helds and vehicle-mount terminals.
7.15.1 Vehicle-Mount ‘Sound’ Parameter Values
Beep tone 2300 500-5000
Beep time
600 0-2000
Error tone 800 500-5000
Error time 600 0-2000
Scan tone 1 1250 500-5000
Scan time 1 150 0-2000
Scan tone 2 2300 500-5000
Scan time 2 150 0-2000
Scan tone 3 3750 500-5000
Scan time 3 150 0-2000
Sound
Range
To Next Page